plingboot
Member
I would very much like to fund a new radio and an AV130, so if it's not nailed down it's at risk of being sold…
Here's my original Hexa 2 PDB with 6 x BL-CTRL's installed.
I built the hexa 2 this time last year and in reality it's not seen much flight time - as i've spent most of this year either working or training for ironman so almost zero time for flying. I'd estimate <3 hours total running time - probably less.
It's in full working order and i'll be happy to rig it up to MKTool and do a short clip to confirm this.
It has the switching circuits installed and working and has a 2x3 block to plug into the flight ctrl.
There are various power connection spurs attached and i'll add a jst to the one without a connector.
The honest bit. I made a slight stuff of the original molex connector and lost the ground tab. I had an email conversation with Lothar at MK and he said i simply needed to strip that wire out of the molex connection cable and solder it to a ground tab on the PDB - and it'd be all ok. I did this and it has indeed been fine - it just means the molex connection cable is hard wire at one point to the PDB.
BL-CTRLs are going for £54ish each new, so how about £200 for the lot, including a brand new and unused hexa PDB* and special delivery within the UK
*So if you wanted to desolder this lot and put it on a new board, you can.
I'd prefer paypal (gift).
If anyone out side the UK is interested, that's fine, but i'll need to confirm an additional postage cost, which will obviously depend on where you are.
View attachment 1221View attachment 1222
ps anyone want some mint condition Oakley juliet sunglasses… ? :nevreness:
Here's my original Hexa 2 PDB with 6 x BL-CTRL's installed.
I built the hexa 2 this time last year and in reality it's not seen much flight time - as i've spent most of this year either working or training for ironman so almost zero time for flying. I'd estimate <3 hours total running time - probably less.
It's in full working order and i'll be happy to rig it up to MKTool and do a short clip to confirm this.
It has the switching circuits installed and working and has a 2x3 block to plug into the flight ctrl.
There are various power connection spurs attached and i'll add a jst to the one without a connector.
The honest bit. I made a slight stuff of the original molex connector and lost the ground tab. I had an email conversation with Lothar at MK and he said i simply needed to strip that wire out of the molex connection cable and solder it to a ground tab on the PDB - and it'd be all ok. I did this and it has indeed been fine - it just means the molex connection cable is hard wire at one point to the PDB.
BL-CTRLs are going for £54ish each new, so how about £200 for the lot, including a brand new and unused hexa PDB* and special delivery within the UK
*So if you wanted to desolder this lot and put it on a new board, you can.
I'd prefer paypal (gift).
If anyone out side the UK is interested, that's fine, but i'll need to confirm an additional postage cost, which will obviously depend on where you are.
View attachment 1221View attachment 1222
ps anyone want some mint condition Oakley juliet sunglasses… ? :nevreness:
