Hexa Frame ? 70cm between motors
DT750 x6
Overlander XP25 25amp ESC
Zippy 3cell 40C 3000 Battery
DJI Naza M
Spectrum AR7000 RX
Gryphon GPD=1000HXP Power Distribution Board
Hi
New to all this
Di my first test flight yesterday on my Hexa as above flew stable but test was short due to Low battery warning!
Was test flying with APC 10x4.7 props but intending to use 11 x 4.7 but cant get pushers at the moment!
Questions
Should I fly with the DJI Naza battery warning disengaed ? Battery was at 75% after test flight.
With these ESC With BEC Should I remove the red wire? Using Naza
http://www.overlander.co.uk/speed-controllers-ubec/xq-xp-25a-programmable-brushless-esc.html
I am going to get new battery so should I go with a 4 cell instead of the 3 cell Could not get my head around this as have seen recomended for the 3cell but that was for single motor not X 6
Many thanks in anticipation of your help.
Regards
Helivis
DT750 x6
Overlander XP25 25amp ESC
Zippy 3cell 40C 3000 Battery
DJI Naza M
Spectrum AR7000 RX
Gryphon GPD=1000HXP Power Distribution Board
Hi
New to all this
Di my first test flight yesterday on my Hexa as above flew stable but test was short due to Low battery warning!
Was test flying with APC 10x4.7 props but intending to use 11 x 4.7 but cant get pushers at the moment!
Questions
Should I fly with the DJI Naza battery warning disengaed ? Battery was at 75% after test flight.
With these ESC With BEC Should I remove the red wire? Using Naza
http://www.overlander.co.uk/speed-controllers-ubec/xq-xp-25a-programmable-brushless-esc.html
I am going to get new battery so should I go with a 4 cell instead of the 3 cell Could not get my head around this as have seen recomended for the 3cell but that was for single motor not X 6
Many thanks in anticipation of your help.
Regards
Helivis