I just finished installing my gimble. When I rock left and right the roll servo arm moves to either side of center depending on which direction I tilt the quad. My pitch is only moving in one direction from center when I tilt the quad forward and backward. I have my gains set to 20 and I haven't programmed my transmitter for manual yet. The pitch Travel Limit on roll and pitch is set to 1000 0 -1000. I am using S Bus so I only have one wire from the Receiver to the MC. I hope I can figure out which channel on my transmitter will manually control the pitch since I'm using S Bus
Any ideas?
Thanks
Rich
Any ideas?
Thanks
Rich
Last edited by a moderator: