Macdoogal
Member
Hi all,
I have a gimbal on the way and I was was wondering about powering it. I'm running a DJI Phantom 1.1.1 with the Storm deluxe FPV kit. I have the FPV transmitter hooked up to the aux power leads from the board. Can I just add the gimbals power wires to them with the FPV? Or do I need to tap in elsewhere? I'm prepared to solder the gimbal power wires right to the point where the battery attaches to the board, but I think it'll be easier if I just tap the aux power in parallel with the FPV. Is that too much load?
thanks,
Macdoogal
I have a gimbal on the way and I was was wondering about powering it. I'm running a DJI Phantom 1.1.1 with the Storm deluxe FPV kit. I have the FPV transmitter hooked up to the aux power leads from the board. Can I just add the gimbals power wires to them with the FPV? Or do I need to tap in elsewhere? I'm prepared to solder the gimbal power wires right to the point where the battery attaches to the board, but I think it'll be easier if I just tap the aux power in parallel with the FPV. Is that too much load?
thanks,
Macdoogal