as a bit of a newbie i'm fighting with the gu-ins on the gaui 500x. I was flying it for the first time yesterday, were everything worked great (only in manual mode till now).
Since of yesterday evening the initialisation process seems to get stuck.
- sensor led blinking red, turning to solid green
- mode led blinking red for a short time, going to unlit state
- gps led and set led are unlit too.
- all 4 motors beeping once every few seconds.
The whole thing does not seems to react to the rc-sender (the receiver gets the correct signal from it and turns on the green led) in any way.
Does anyone of you have a similar problem or knows what i can try to solve the issue (whatever it is...)
i've also downloaded the latest firmware 1.4 to it, without any change to the problem. all channels correctly set up with the rc.
thanks for any help or ideas i can try out
cheers, manni
Since of yesterday evening the initialisation process seems to get stuck.
- sensor led blinking red, turning to solid green
- mode led blinking red for a short time, going to unlit state
- gps led and set led are unlit too.
- all 4 motors beeping once every few seconds.
The whole thing does not seems to react to the rc-sender (the receiver gets the correct signal from it and turns on the green led) in any way.
Does anyone of you have a similar problem or knows what i can try to solve the issue (whatever it is...)
i've also downloaded the latest firmware 1.4 to it, without any change to the problem. all channels correctly set up with the rc.
thanks for any help or ideas i can try out
cheers, manni