Aeroxcraft Futaba S3156 frequency

[Joffa_Dan]

Just in the process of setting up my aeroxcraft gopro gimbal powered by CC 10A BEC @ 6V.
A very simple question. Has anyone tried running the recommended Futaba S3156 servos at 400Mhz frequency on the Naza gimbal control? Is this too high for them?
I wanna try it but don't want to burn them out if it's going to be too high.

 

[jes1111]

You mean Hz, not MHz - most digital servos run a maximum of 333Hz - a 400Hz signal probably won't hurt it.

 

[shaonss]

You mean Hz, not MHz - most digital servos run a maximum of 333Hz - a 400Hz signal probably won't hurt it.

I was trying to tune up my AiroXcraft Gopro Gimbal and burnt one servo.
My pitch was smooth but roll was jumpy. so I kept testing different settings. Next thing i smelt was a burning smell. Servo is fully locked out. would not move at all. servos are directly connected to my Naza F1 and F2 port. These servos costed me $47 each.