Fail safe question
This has nothing to do with my previous crash post, I am looking for a little better explanation of how the failsafe function works on the WK-M. I programmed the fail safe option to a switch, so I could test it out and see what it does. I was flying my quad at about 6 feet, when I initiated it, it went into a hover for about 5 second then it climbed, not knowing what it was going to do I immediately switched out of the mode and took over the control again.
I did it again this time I was a little more patient, so it climbed up and level off around 30ft, I waited for about 10 seconds, however again not knowing what it may do I then took control over again.
I am thinking this maybe normal, but no sure and have not found much explanation about the procedure. So if anyone could let me know I would appreciate it.
Cheers thanks Jack
This has nothing to do with my previous crash post, I am looking for a little better explanation of how the failsafe function works on the WK-M. I programmed the fail safe option to a switch, so I could test it out and see what it does. I was flying my quad at about 6 feet, when I initiated it, it went into a hover for about 5 second then it climbed, not knowing what it was going to do I immediately switched out of the mode and took over the control again.
I did it again this time I was a little more patient, so it climbed up and level off around 30ft, I waited for about 10 seconds, however again not knowing what it may do I then took control over again.
I am thinking this maybe normal, but no sure and have not found much explanation about the procedure. So if anyone could let me know I would appreciate it.
Cheers thanks Jack
Last edited by a moderator:
