DJI Naza WOW!! But a few questions??

J

Jesper

Member
I'm out from my first flight with the Naza FC in my X650. Everything was great! It's super stabil :)

But I don't understand that LED blinking! Everyting boots up perfect, I set it in Atti mode, orange led flashes, all is fine, but when I give it throttle to climb,
the led turns to flash red. I land it and take it inside to see what's up, before i turn it off the LED has changed to flash orange and green.

Why does it blink red on climb, and why did it turn to blink orange and green at the same time?
 



E

Elliott000

Member
I turned it off and fly by timer on my radio, be sure to do a test flight for 5 minutes and see how much mah u put back in then u can figure how many minutes u can fly
 

Rick~K

Rick~K

Free Bird
I checked my pack 1st with a multi-meter and got a voltage reading, then in the assistant select 3S and then click calibrate and see if it has the same voltage also I use the default voltage. Then save it. If you been flying a while the 3s will show red flashing on a power climb. I use 2 3S 2200's if I'm just messing around w/o a load (camera). When I see the red flashing on power climb I know its almost time to land.
 

M

mailman35

Member
i perfer to fly iwith the voltage monitor on, it stops me from flying below 20% . i think i have some screen shots somewhere of what i have my my 3s quad.
 

F

fayrwerks

Member
anything below 3000Mah 3s will not be enough for the X650... it will be fine for hovering and slow climbs on unloaded frame but with cam and FPV... sooner or later you'll flip your quad...
 

You must log in or register to reply here.
Top