Onen-MW

New Member
Hi i have built a 8 prop octo copter and its 1.1m wide, i am using radiolink at10 but am facing a few problems. is there any one that can guide me. i am using pixhawk with missionplanner. the first thing is that made mods to the remote. i added the spring and would like to us the handle set the limit. example if i take the throttle up from the middle it should take a lift up and then when i leave the handle it should stay the same place unless i push the lever down to reduce the throttle instead it works bonkers. the minute i arm it the props go in action. it show they at 50 percent.
any ideas on that.
 

Top