padmaja mailapuram
New Member
hi..
please help me to run a multirotor motor using simonk esc... i am using arduino uno to control esc. and potentiometer to vary speed of motor which is connected to arduino board ..... following the below link ....
http://experimentaltechnik.com/simonk-esc-arduino/
i am getting 2 beep sounds but motor is not at all rotating....
i am following the same code as the above link....
please help me....
i am very new to all of this.... just a learner....
thanks in advance for replays....
please help me to run a multirotor motor using simonk esc... i am using arduino uno to control esc. and potentiometer to vary speed of motor which is connected to arduino board ..... following the below link ....
http://experimentaltechnik.com/simonk-esc-arduino/
i am getting 2 beep sounds but motor is not at all rotating....
i am following the same code as the above link....
please help me....
i am very new to all of this.... just a learner....
thanks in advance for replays....