cschwab145
New Member
Hi all,
So this is my first quad build, so naturally I’m running into many errors. I am using a MultiWii Pro 2.0 FC (QUAD X) and I’m using the stock code that came from the website I purchased the FC (https://www.dropbox.com/sh/whg6qn4d50c9trk/mRJz9CCTUq ). I’m also using a Turnigy 9X Tx with a 9X8Cv2 Rx in HELI4, PPM, MODE 2 stick set.
I have three main problems/questions:
1) I notice that when I power up the FC board there a MANY LEDs that are on constantly (not flashing). These are LEDs 1(RED), 2(BLUE) and 3(GREEN) at the bottom right of the board and two other LEDs (RED and BLUE) that are in the bottom left of the board right next to the FTDI USB controller. What do these LEDs represent???
2) When my board is powered and I open the MultiWii GUI and connect to the correct COM, I notice that the live Pitch, Throttle, Roll, and Yaw levels are not centered at 1500. How can I center them? Also, When I move my throttle my Roll levels also change… any tips here???
3) Finally, my motors will NOT arm! From my research I’m assuming this has to do with question 2 above…
Thanks in advance! Any help, suggestions, tips, or pointers are greatly appreciated.
So this is my first quad build, so naturally I’m running into many errors. I am using a MultiWii Pro 2.0 FC (QUAD X) and I’m using the stock code that came from the website I purchased the FC (https://www.dropbox.com/sh/whg6qn4d50c9trk/mRJz9CCTUq ). I’m also using a Turnigy 9X Tx with a 9X8Cv2 Rx in HELI4, PPM, MODE 2 stick set.
I have three main problems/questions:
1) I notice that when I power up the FC board there a MANY LEDs that are on constantly (not flashing). These are LEDs 1(RED), 2(BLUE) and 3(GREEN) at the bottom right of the board and two other LEDs (RED and BLUE) that are in the bottom left of the board right next to the FTDI USB controller. What do these LEDs represent???
2) When my board is powered and I open the MultiWii GUI and connect to the correct COM, I notice that the live Pitch, Throttle, Roll, and Yaw levels are not centered at 1500. How can I center them? Also, When I move my throttle my Roll levels also change… any tips here???
3) Finally, my motors will NOT arm! From my research I’m assuming this has to do with question 2 above…
Thanks in advance! Any help, suggestions, tips, or pointers are greatly appreciated.