Mikrokopter 360 degree turns

[crcr]

I'm using the lastest firmware (FC .88e and Navi .28i) It seems to be flying very well but have noticed something weird when spinning the MK 360 degrees on the spot.
I took the MK up to about 30m and did a very slow (15 or so sec) 360 turning clockwise and it held on the spot very well (no wind) but if I turn the MK counter clockwise it doesn't hold tight on the spot and does a slow toilet bowl type circle about 6-8m. Anyone else seen this or know what causes this?

If I turn the MK fast (4-5 sec) in both directions it holds very well.

Any help would be appreciated.

Thanks,
Craig

 

[ovdt]

crcr,

Can you try this:

Hover over a spot and give lots of throttle so your copter climbs fast. And while climbing, check if you see any uncommanded yaw.

 

[crcr]

crcr,

Can you try this:

Hover over a spot and give lots of throttle so your copter climbs fast. And while climbing, check if you see any uncommanded yaw.

Yep I've tried that a few times and it goes straight up without any yaw.