Search results

  1. T

    F550 struggling with 1.7kg takeoff weight

    I figured I'd chuck all the gear on he F550 and see how it performed. I've not physically weighed it but going on all the weight specs for the kit I have purchased it should be sitting around 1.7kg in total. I fired it up in my lounge and I was less than impressed, hard to get to ceiling height...
  2. T

    SimpleBGC Ho wto add pitch offset?

    Hi as per title really. I have a burshelss gimbal controller, im not really sure what it is as it came with a cheapo gopro gimbal but I robbed the board and used it on another gimbal, it works really well. I am using SimpleBGC to configure it, is there any way tell it to offset pitch a little...
  3. T

    Anyone know where else I can source these leds?

    http://www.ebay.co.uk/itm/Dji-F550-Flamewing-Hexacopter-Quadcopter-Strobe-Flashing-Led-Kit-/111177963386?pt=UK_ToysGames_RadioControlled_JN&hash=item19e2b9177a I've tried to contact this guy time and time again to ask questions about the product, specifically about programming the light and...
  4. T

    Help, struggling with landing gear + RC Timer Gimbal for F550

    I have an F550 and recently added an RC Timer gimbal to my inventory. Initially I had the AeroXCraft landing gear (which is very nice) but at full extension of the gimbal I dont have anywhere near enough ground clearance from the landing gear. Does anyone else run this setup and can you advise...
  5. T

    Payload and flight times for stock DJI + landing gear?

    I recently built an F550 and not sure what my maximum payload would be, im looking at lifting a body and lens of about 350g along with the aeroxcraft landing gear and a gimbal suitable for the job. Right now I run a single 3s 3000 with the 10" props, what would I be looking at changing to lift...
  6. T

    Broken my blades whats my best budget option

    I was flying this morning, had a good flight, landed and took off a good few times. My post flight inspection revealed broken blades, the tip clean off one and a chunk out of the other. I didnt crash into anything but there was dirt on the blades too, I guess this was caused by stones flying...
  7. T

    Records home position but crashes to the ground :(

    Hi, My naza m v2 looks liek it records the home position (rapid green blinking), but if I tur off the transmitter is just comes crashing straight down. Normally, after the rapid green flashes, I see two green flashes and thats how it stays during flight. What am I doing wrong?
  8. T

    Cannot get NAZA M to enter compass calibration

    I posted in the build section but very quiet in there today. I have just built a 550 with naza m v2 with gps. I only have a DX6i transmitter so no 3 way switch. I set the flight modes to GPS and GPS atti on my gear switch. According to the dji wiki, to put the naza into compass calibration mode...
  9. T

    New to MRC, Just built a F550 (compass problems)

    Hi! As much I'd love to be able to fly real RC heli it just doesn't click but I had a play with a phantom & fpv about 6 months ago and was amazed at the stability and controllability of it. As a keen photographer I'd like to get a decent stills camera in the air, something like this...
  10. T

    lips becs and auxilary power usage

    Hi I have just purchased my first MR. A DJI F550 and NAZA M v2 FC. What is the best way to suppy power to other stuff on the platform? Does this happen through the receiver (for a gimbal) or do I need to T off the main power to the bec for stuff like leds, gps trasponders etc etc. I really...
Top