Search results

I'll design it myself then.

Wow! got the STL files? :nevreness:

So anyone got any leads to a 3-axis BGC that can handle some power? Or is there a way to put in some booster between the BGC and the BGM's?

Changed out the hitec servo's for savöx! The hitec do not work with wkm. Bouncey as £#$¥ and so totally useless. The new savöx work flawless, no jitter and bounce, but not fast enough on 6v and will try 7,2v tomorrow Was told my gps will be back soon, after way to long.... Hope to get some...

Okay!

nope.

I just use a 2s lipo in my t8j Works fine You can put in a bec, room enough in the back.

Free shipping for all Navigator motors And 40mm MT within the EU for orders from 21-12-2012 to 28-12-2012 This is ONLY for the Navigator series and 40mm MT series. Minimum order 4 pcs. Orders via PM only. MT4006 740 KV MT4008 380 - 600 KV MN4010 370 - 475 - 580 KV MN4012 340 - 400 - 480 KV...

So I've returned my old one and got something back. Not what he said it would be. No pot on the roll. So now made that myself. what is nice is the alphagel block under the camera butttttt when doing a shot down your cam can go down as well! It's not secure at all and needs modifying as all the...

Wahaha a tx ;) okay thing at low price for a 9ch when I bought it.

Sooo my core is bad. Trappy is sending me a new one to swap out. great service! The next problem has arrived! the EZUHF with the wly WTF09SII and ppm connection to the naza, traditional setup doesn't function as well. Think the wlfy doesn't function so looking for a futaba to fix the problem...

for the navigator series there will be: 4010: 370-475-580kv (130grams) 4012: 340-400-480kv ( 152 grams) 4014: 330-400kv (169 grams) 600mm kabels with 3,5mm bullet plugs

Thanks for the advice, was already soldering the stuff on the pads as you was typing the post. Found thad the small plugs and the pads do not line up... still not working... Going at it again later today. thanks for all the help and tips so far.

Euh that is printed on the vtx. I'm using the small connector on the back side of the vtx. Maybe the problem lies there. Tested the cam and that works just fine but tested it with the large black connector.

Hi guys, The separate power cable is because the vtx has a separate power plug and a plug for the signal...

The vtx is getting its power thru the solder pads. The signal is going thru the small wires behind it. The vtx works fine, the problem is in the cables or core or cam or programming in one of these, could pal/ntsc give the problem?

No the vtx is powered by the vtx connection side. The cam is powered by the cam side I wish to power it thru the core: 1. I payed for it :-) 2. it's filtered this way both the cam and vtx are soldered at 12V the osd is enabled.

oh and got this from trappy... this shows something different from the build video instruction on his site.

Did my best but it's not great. no macro lenses... The connection to the bottom board to cam the connection to the vtx, immersion 5,8 the two on the front are the power and in the back the extra ground, video and audio The connection to the vtx, skipped the 5v power and the ground vid and...

I'm having the same problem not getting any video thru the cam and the core. The vtx and vrx work fine with the go pro but not with the 69 and core connected.