Search results

  1. K

    Need some help with calibration

    Finally got everything set up!! Thank you for all the responses. I used the software to reverse the necessary channels and also had to physically swap the cables between the receiver and naza for the elevator and aileron channels. Now to practice my flying skills! Thank you again for the...
  2. K

    Need some help with calibration

    Thank you for the feedback guys. Very helpful. PeteDee, my 1 and 3 motors were spinning the wrong direction, so I swapped 2 wires on each. I was able to get the quad flying after doing that. Yee-haw! However, my control sticks are still not right. So, my first few flights didn't go so...
  3. K

    Need some help with calibration

    I have a DJI F450 kit with a Turnigy 9X running ER9X firmware. I'm having trouble getting my quad to fly. I think I need to calibrate my transmitter but I don't know how to go about doing that. Here are the symtoms: 1. Max throttle appears to be when the left stick is at the bottom and...
  4. K

    How do I power the receiver?

    Fantastic!! Thank you!! I appreciate the help!
  5. K

    How do I power the receiver?

    I have a DJI F450 kit and Turnigy 9x with ER9x firmware. I've got the receiver wired up to the naza controller. And, I've got the Naza USB port wired up to the battery, and the other 2 cables going to the naza controller. How do I get power to the receiver? Does it come from the naza...
  6. K

    How to connect speed controls to motors?

    I've got a F450 ARF kit. The speed controllers have single letter labels on the connections to the motors. But the motor wires are not labeled. How do I connect them? Or does it not matter which wire goes where? Thank you.
  7. K

    Questions about flight controllers and props

    Thank you for the response, Chris. I just ordered a F450 package complete with Naza M Lite and GPS. I noticed on the Naza info that the failsafe mode says "If your transmitter supports failsafe, then you can set failsafe through port-U." How do I know if a transmitter supports failsafe...
  8. K

    Questions about flight controllers and props

    Quick background: I have been into R/C trucks and cars, so I am familiar with R/C. However, I have never flown a quad or any aircraft before. I just bought a used Heli-Max 1SQ to help in learning. Ultimately, I'm interested in getting my GoPro Hero2 up in the air, and have been researching...
Top