Search results

I have run out of ideas for this Hexacopter I am building, using DJI Wookong m have gone through the assistant software established everything is working had an issue with ESC incompatability but fixed that with new ESCs can test each motor from the assistant software radio throws set up...

Hi all I have a new development I did a restore factory defaults and set up everything again. I am starting to think I have an issue with the IMU when I go to test the motors through the the assistant software only one motor works if I swap the leed with another motor it will work in the...

Well I have calibrated the GPS and as best I can see it is working ok maybe you can confirm for me. Switch to GPS mode get a single purple flash about every second. In Atti mode I get a single yellow flash about every second and in manual mode I don't get any flashing at all. Tried to fire up...

This is a new system so yes it needed setting up I have however not calibrated the GPS thinking that in manual mode it should fire up am I wrong in assuming that. Thanks very much in advance Phil

I have the DJI Wookong M Autopilot system with 50 waypoints. I have connected to the assistant software and set up the system. first thing was the upgrade then the set up. I have calibrated the radio and confirmed it is not reversed and done the end points for the switches. The throttle follows...

Hi all I am setting up my Hexa at the moment and have come up with a problem I have run out of ideas with. I have Tarot motors with Turnigy Plush 30A speed controllers. I have done all the basic setups for the system which has gone well and are at the point of firing up the motors. You can run...

Thanks mate I tried that yesterday it did not when everything is turned on and GCS is up you can see the Hexacopter on the computer screen so I am assuming all the settings have been loaded successfully into the system. Is there any way you can check to confirm that the settings. After any...

Hi guys I have just completed my hexacopter and have a problem I was wondering if you could help us out with. I have built a Tarot 680 using the tarot 2814/700Kv motors on a 5000MA 14.4 lipo with 12x4.5 props. I have installed the YSX4pro system and set it up using my Windows 7 PC. I have run...

G'day everyone been in RC for 30 years on and off I fly scale through to full aerobatic along with gliders. I am president and instructor of our flying club and have never got sick of flying. My wife also shares the passion and flies as well so my build table is in the family room which is...