Search results

Hello All, I need help. I am want to mount my ZenMuse H3-2D gimbal on FCModel M-200 landing skids for a FlameWheel F550. None of the holes and slots on the 2 mounting plates that came with the landing skids match up with the gimbal's screw locations. Does anyone know of any after market...

Ben- I am pretty new to R/C quad copters. Built my FW F450 in late June so I've been flying for about a month and a half. I adjusted the Elevator trim so that the neutral position is zero, but that changes the range from -1000 - 880 to -940 - 940 in the Naza assistant software. When I look...

I tested the RTH failsafe feature again this morning and everything is working fine. I waited longer for the GPS to acquire the satellite signals and had no trouble getting the copter to Go Home and Land when I flipped the flight mode into Failsafe. I also tested what would happen if my Tx...

I plugged my DJI FlameWheel F450 into the Naza assistant software this morning and noticed that the neutral position of the Elevator control was somehow "bumped" to -85. When I push the Elevator up it maxs out at 880. When I pull it down it goes all the way to -1000. Rudder and aileron go to...

I installed the Naza GPS module on my FlameWheel F450 today. After calibrating it, I tested out the RTH feature and had the following experience: after hovering the quad about 6 ft off the ground and about 15' from the launch position, I activated the Go Home Landing failsafe. The copter rose...

I have the same issue. When I power up the gimbal the red light on the GoPro comes on, but the camera's screen does not. I have to manually turn the camera on and then hit record before I fly my quad copter. There is a setting on the GoPro to make it automatically start recording by just...

Thanks for your help Pete, I figured out my problem was that I was plugging the USB cable into the ZenMuse GCU and I should have been plugging it into the LED module. Got the firmware updated to 3.14.

Hello, I just installed my Zen Muse H3-2D gimbal on my FlameWheel 450 today. Everything seems to be working fine, but I need help upgrading to the latest firmware. The assistant software says to download the update from the website and the website says to upgrade from the assistant software...

I just built my first multi-rotor (DJI FW 450) and learned how to fly it. I have 4500mAh / 4S / 14.8v / 30C batteries. How low in voltage is it safe to go? I am using a Spektrum DX8 transmitter. I just hooked up the telemetry module and re-bound the system but the battery voltage isn't...

Can the ZenMuse H3-2D gimbal be independently controlled by a 2nd radio transmitter for 2 person operation? Can it look straight down? I was reading the manual and got the impression that it might require the DJI GPS module. My FlameWheel 450 doesn't have the GPS module on it and I fly it...

gtranquilla, I read your post on term_paint's thread and had a question for you since you know a lot more about this stuff than me. I have a DJI FlameWheel 450 with RCTiger 2814-10 motors (770 kv). I was going to switch to 4S batteries, but I just ordered a Beholder Brushless gimbal. The...

I just ordered a Beholder Brushless Gimbal for my DJI FlameWheel 450 from CNChelicopter.com. I was wondering if anyone has any experience using this gimbal? The instruction manual says to use 2S or 3S batteries, but since I just installed some RCTiger 2814-10 (770 kv) motors on my FW450 I was...