Search results

I have eight motors in my coaxial setup, and therefore I have plugged two ESC's into F1 and F2. Now gimbal works, but gimbal travel is limited anyhow.

Hi, There is problem with AV200 and WKM. I have X4-setup and therefore I connected gimbal servos to R and T connectors. I enabled gimbal on assistant software, but servos does not react and assistant shows X2 and X3 are 1000. However, when I disconnect servos WKM works normally. Any idea what...

Okay. It would be just nice to let photog control 2D gimbal stabilized by FC and not need to pay for second stabilization system. Maybe DJI could implement this in next update?

To control tilt(pitch) and still have stabilization? I assume this is impossible with WKM, or could second RX use X3 if main RX is connected to X2 with S-BUS? Or should I have dedicated controller with 2D-gimbal (AV200)?

Thank you, Patrick. I already have one DW PDB and feel safer to use it now, after getting answer from you in addition to multiple websites. Our payload is smaller due usage of DSLR.

Hi, I'm building Droidworx Skyjib X4 Titanium with 3515-KV400 and 6S batteries. Is one DW's PDB enough or should two be used? Wire spider could be one solution too. Does large dome cover two PDB's and WKM?

Hi, I'm planning to build multicopter, either traditional octo or coaxial setup. I'll using Wookong-M and would like to have 360 pan with AV200. I have understood that WKM is not working with panning, so would for example Picloc or Skyline RSGS work? How to connect two Futaba controllers to...