Search results

can i use xaircraft 650 v8 motor with 4s battery or only 3s battery thanks

i have a question if i build a hexa copter with wokong M or Naza and RC timer motor and ESC and as I read they all support 6s lipo is there any problem not to use and when to use 6s or 5s if your ESC and MOTor support it just wondering why people mostly try to use 4s or 3s is that...

Thanks again I want to keep the motors but do not know if those motors take $s Battery / any idea on that .

Thanks for the info's but can I ask why did u replace the motor ? and how much the new motor cost , what size battery do you use and the total weight without the battery thanks in advance

Hi guys I got xaircraft V8 want to change the controller to DJI Naza so I am just wondering what capacity battery can it takes ?????also what Amp ESc can the xaircraft motor can handle please kindly lewt me know and if u hnow of any good ESC and cheap one plz let me know thanks

Does any one know where to find the 4 pin wire that goes to OSD mine is damaged and could not find it any where it is OSD mark2 that one that u connect to osd then to camera I do not know what u call that micro connector Thanks

R u saying that i set everything in default and do advance calibration? no i did not i will try that tomorrow thanks

no it is in gaui 500x frame

Hi guys i just updated my dji Naza with new firmware and replaced the traditional Rx to S-bus it started doing strange things like going up and then down by itself with out me touching any stick and got kind of shaky despite adjusting the gain

Thank u all

Hi as any one used remzibi osd with dji Naza or WKM just wondering how to connect t hem since there is no manual and Remzibi comes with its own GPS as will

Hi as any one used remzibi osd with dji Naza or WKM or ZEROUAV just wondering how to connect t hem since there is no manual and Remzibi comes with its own GPS as will

can some one tell me what is out put voltage of a Rx i got futaba Rx and need to connect some thing that does not take more then 6 v thanks

THANKS FOR REPLY I use QAUI 500 frame i did calibration i will do it again but it does not go in circle it just go to one side it is the front

Hi guys i just build a DJI naza lite with GPs the problem is when i use GPS it suppose to hold position but actually it moves and so i have to use stick to keep in place even though it is locked and i see GPS green lite is flashing has any one else got the same issue?????/

Hi in this setting which channel of Naza goes to which channel of the Frsky RX ? thanks

thamks for your information but i am confused about OPTO is it non BEC or with BEC I use this ESC http://www.rctimer.com/product_850.html

Hi I built a Hexa with WKM and RC timer 40 OPTO ESC in DJI manual it says you have to remove the red wire but i was told by some one that that is for non OPTO in OPTO You leave the red wire connected please let me know which one is correct thanks

singel wire but which one red- white -black thanks

Can one explain what each of the data fields mean? (no load, line loss, loaded)? Little confused by this terminology? also i could not find any infos about battery setting in dji manual for voltage