Search results

Almost !!!!!!!!!!!!!! I now have all four motors coming on but #1 starts later then the others, and may be slower Bill

Jay, Just recalibrated the escs with the clothespins , tried the throttle and now I have all the motors starting together except motor #1. Motor #1 does not run at all. I would be all set if this was a tricopter, but its not. Originally all that ran was #1, but now not so much. Bill

I guess Ill put the wires back as they were , and try calibrate the escs , now where did I see those clothespins . Bill

Jay and Friends, I just made up jumpers so I could connect the outputs of # 1 motor esc to the input of #2 motor , leaving all the escs plugged into the kk2 as they were. Now motors 2 , 3, and 4 all came on. There is one thing, they came on at different throttle settings. Can someone explain...

I hate for something to get the best of me, but this quad stuff is all new and there seems to be a lot of variables. I ordered my naza m lite and the 450 quad from ebay. It came with the wires, the escs, the motors a separate 5 volt power supply, and led. Im thinking both the lite and the kk2...

I am using hobbyfans 30a 40escs . What I don't understand is why the number 1 motor starts after calibration , but none of the other three will not. Also in the kk2 manual it mentions something about a red wire on the other three escs may have to be removed , except in the case of a quadcopter...

cootertwo, This morning after looking at another utube , I programed #1 motor esc by plugging it into the throttle position on the receiver, bypassing the kk2. After doing that the motor started and worked fine. Then I tried the same thing with the remaining escs , but none of those motors...

Thanks guys, I tried cc3d , then a 450 with naza lite and gps, Could not get the motors to arm. I tried plugging them directly into the receiver and they work. Tried setting up fail safe by watching a utube video and went step by step doing the switch setup, still no motors. Bought a kk2 ...

I have been in rc for a very long time, and have flown all kinds of model planes. About a month ago I decided to try my luck with a quad copter. I bought a 450 size with a naza-m lite controller. I am using a hitec 9x transmitter and a 9 channel receiver. The assembly was the easy part, but the...