Search results

That's a great idea. Wish I would've thought of that beforehand haha. Good news is the motors are running right and the response seems smooth. I'm not sure about calibration abilities but I'm going to spend more time reading and researching. On a side note this thing is going to be scary fast. I...

Admittedly yes I did fly it inside. I was simply wanted to get it off the ground to make sure the motors were spinning right. I'm running the cc3d controller and went through all the calibrations on the gsc. I'm gonna need to look at it more closely. It did drift backwards both times

Makes perfect sense. I think it goes without saying I'm not the most technologically literate drone builder yet haha. Good news though, got the ccw motors running right! Got 2 liftoffs before breaking 3 props. It didn't have any problem whatsoever getting off the ground but its wandering...

I'm def planning on swapping the leads. But there's 3 wires. One is a signal wire, so I need to assure that I'm not swapping it.

Thanks everyone! I def plan on it. I kinda need help now though, my ccw motors aren't spinning ccw. So I need to reverse the polarity. Could you take a look at my photo and tell me from top to bottom which wires are what? I'm afraid to cut and splice without knowing 100%

extremely lucky. it was a 5030 tri-blade and it was def up to about 80-90% throttle on a 4s... so you can imagine the urgency that prop had when it came off. the endgame with this particular drone is a light as possible fpv racer. im not going to actually race it, but strictly for acro and...

Thank you for the response yeah I don't have anything sitting around that I could use to temp power it. Think I'm just gonna wait for the ubec to come in then go from there. It's annoying to have to sit here and stare at it after spending so much time researching, ordering parts, building it

hello all. currently trying to finish up my 250 class build. below is my hardware list. frame- QAV250 ebay knock-off motors- Sunnysky 2206 props- (training) gemfan neon green 5030 tri-blade, (racing/acro) gemfan nylon 6045. esc- Spider 15a OCTO ESC w/ simonK FC- CC3D Tx/RX- F00541 RadioLink...

hello all! names brent and im from jsut south of Pittsburgh pa. currently finishing up a 250 class drone. was testing my 5030 tri-blades yesterday and the bullet nut came off at 90% throttle... almost had to go buy an eye patch for the wife...