Search results

glad you got it sorted, definitely something off in the nasa lite firmware, HW is almost identical between them so I'm guessing DJI have intentionally or not made it not as stable, got to have something to get people to upgrade to V2 for, Wait till you try manual mode, man did it today for the...

Tis odd this, one thing i have noticed roaming the forums is the Naza lite does seem to have some stability issues compared to to V2, as the HW is the same people have been flashing it with M V2 firmware and have seen big changes in performance, its down to each person if they want to hack...

don't sound rite that, if he is adding sub trim on the Futaba then he is also having the same problem and compensating for it with the trim, if everything is calibrated in the nasa assistant then it will take centre from where the sticks are, in the nasa assistant with the sticks centre is...

Just some information on the Tarot ZYX22 controller on the gimbal, i bough a T-2d t one on eBay cheap (£25) that was dead, after some checks i had a dig around, checked the fuse and that was fine, followed power to the 5v regulator and that was good, then followed on to a transistor labels 662M...

colour placement is irrelevant, you could go in any order you like, what matters it motor locations and rotation directions, you chose where front its going to be, and then setup the motors as per the naza mixer type attached , the colour its entirety up to you DJI always seem to stick red at...

How did you get on with this ?

Hi All i bust acquired a Tarot T-2d thats dead , the ZYX22 won't light up or connect to PC, don't know its history, any one got ant fault information on these, it won't connect to PC on either board so i suspect its a power issue, iv checked the fuse on the board and I'm getting voltage to the...

its been a long time since DJI released any updates for the M V2, I'm wondering if we will ever see any new features ? I'm guessing there will be an update sooner rather than later to "Fix" ability to install on the lite.

Well nothing I can really offer more I am afraid. I build mine last week with the M V2 not the lite and had no issues at all. Perhaps it's something in the lite firmware that's different to the m v2. Hopefully some one else with far more experience will chip in

Just spotted that still a big battery. What's the weight ?

I read somewhere in the naza manual that at very low level it will assume you intend to land and try to settle down. Think this is in gps and att mode only. Send it up 10m and see how it sits. Personally I'd also connect the tx to the app do any firmware updates and calibrate everything in...

have you calibrated that TX in the Phantom RC app ? i did mine and there was also a firmware update for it, micro usb on bottom

yes it is, it look like in the vid you had double flashing all the time ? when you send it vertical and centre the sticks and it starts do drop by its self does it flash single or double ?. what is you all up weight with battery ? also hovering that low it may try to enter landing mode ?

I have been reading around with regard stop fly aways and possible interference to the GPS, Looking at my F450 today i was wondering if a fully screened top and bottom board would help, the top board currently has tracks left around the edge and the holes but was thinking would a fully copper...

Did I see duel flashing green lights when you were off the sticks ? This would indicate sticks were not centre, have you double checked calibration of sticks ? In hover with sticks in center it should be single flashing light, what radio you using ?

can you take any video ?

Hi All, recently joined, just built me first Multi, F450 with Naza v2 and DT7 TX, build went fantastic, just trying to get the wether to change so i can get out. few pics just added some front led's

try the recommended gain settings from the nasa manual for the f450, these worked fine for me, Basic Gain Pitch 150, Roll 150, Yaw 100 Vertical 105 Altitude Gain Pitch 150 Roll 150

quick question re nasa v2 , when flying in att mode indoors with gps fitted will it still flash no GPS signal on the led's ?

I have a question or two Can you calculate how much capacity you have used from how much the battery takes to reach full charge ? is there any losses in capacity it takes to recharge ? secondly the 3v per cell lower limit, does this include under load ? battery voltage can recover have a volt...