Search results

I forgot to say, the application I use with my ipad is "ground station"

if you connect the ipad with the BTU module via bluetooth 4.0 must you execute pairing or is it without pairing?

I would like to buy a dji waypoints system for naza V2. The receiver station has a DC plug for a battery 9,9- 25 volt. It likes me useful if you use an ipad with bluetooth but I ask myself: Do you need a battery if you use usb connection with a PC?

must I do 2 bindings: a nomal inding and a preset failsafe binding?

I've tried a new orangerx r800x radio and the normal binding succeeded. So thus this mean my radio became defective by the failsafe binding trial? Is it dangerous to do failsafe binding or do I have the wrong instructions?

I have a naza V2 coupled with an orange rx R800x. As a collegue in message before advised me to bind failsafe after a nomal binding I supose I did it. I based my failsafe binding on h following tekst from the internet...

So when I understand it correct this means when you switch the control mode to the naza fail safe;you execute the return to home and landing feature. When you loose TX signal the receiver executes the receiver lfailsafe and uses the throttle set at failsafe binding. When you connect assistant...

I mean a naza v2

I have a naza vR with an orangeRX R800X 8ch which integrates failsafe. My question is: do I need to do fail safe binding if I use the home and landing feature of naza? The preset failsafe binding uses the trottle,elevator,.. set at the binding so i think home and landing cannot function.