Search results

That's not true. I think you need to read the A2 manual again as it does state that it needs to be positioned correctly in regards to location.

Easiest and most helpful way is to buy an IOSD markII and that will have 3 can ports on it which you can plug your gimbal and lightbridge into. TBH good luck on getting lightbridge to actually work, my team has only gotten it to work on the bmpcc gimbal and that was only once.

I hope you know that the IMU and the compass are separate from each other and calibrate differently. IMU is the gyroscope the A2 uses to stay level and adjust motor speeds to keep it level in ATT/GPS mode. Also puck shouldn't point straight forward, there is a calculation to get it in the...

Always do an advance IMU calibration and a compass calibration before anything. Could be your gains, also check to make sure that your Gps puck is pointing in the right direction for your part of the world, it's different for each longitude.

Just buy a f550 frame and replace the broken pieces. The Naza and the motors should be fine. Don't fret, this is an easy fix. As far as the fail safe goes, well there are a lot of variables, your home position could have been set in the air if you were impatient, check the software to see if the...

Do you still have the other dampeners that came with the gimbal? I suggest trying the different dampeners to see what kind of results that gives you