Search results

I was able to fix the issue it was the receiver advanced protection. I just had a 15 minute flight and everything was perfect.

Hey, l am going to extend my esc wires on this tbs discovery I'm starting next week( waiting for parts). Did you soder bullet connectors to the wires to extend them? Or did you just soder them and heat shrink.did you use the same gage wire as the esc or thicker? I don't want the same issue.

Hey, I'm new here and pretty new to multicopters. I have atg-16-680mm x quad naza m v2 gps hobbyking f30 simonk firmware 9-5 carbon props emax 935 kv 2-3s 2200 lipo in parallel After I start to fly everything is stable. I fly a few slow maneuvers and then it wants to land wherever the copter...

Atg-16-680mm naza m v2 w/gps 2-3s 2200 lipo in parallel 9-5 carbon fiber props hobbyking f30 esc with simonk firmware Please I'm stuck here guys! Any suggestions?

My naza is new. It is flying well the gains seem fine. I a have a dx7 with no failsafe set up. It flys great for only a few minutes then lands wherever it is, even with full throttle. It is not in failsafe mode or voltage protection mode. It just gradually takes the power from the esc's to...

Hey, I have a issue with my new build it is a x quad with naza m v2 I have a spectrum dx7 and a ar6200 receiver. On my test flights it is flying great no problems then three minutes in, it lands all by itself no matter if I give it full throttle.it is not in failsafe mode or voltage protection...