Search results

I use the gimbal channel for gain. It's ok, I'll use my 3 channel decoder, it's already set up as channels 9, 10 & 11. I only need 2 more, so channel 8 for video switcher and 9 for gimbal pitch. Sent from my Z30 using Tapatalk

Doesn't work. You can add a decoder as I have to give me channels 9, 10 & 11, or more obviously. Only the top end receivers such as the 7008 can have the physical channels reassigned from 1-8 to 9-16. Sent from my Z30 using Tapatalk

Futaba 14SG and r6108sb Sent from my Z30 using Tapatalk

How does that get programmed in the radio, it's not like there are 2 channel 1's. Sent from my Z30 using Tapatalk

So if say channel 1 was aileron on sbus, I can use channel 1 on the actual receiver for say a video switcher linked to a switch? Sent from my Z30 using Tapatalk

Hi If I've got my Naza connected via SBUS and I'm using channels 1 to 7, am I right in thinking I can't use those physical channels on the receiver for something else? Cheers Andy Sent from my Z30 using Tapatalk

Ok sounds sensible, but the cause is the hub? Is that masking the problem? Sent from my Z30 using Tapatalk

I always balance blades to get it sitting horizontal first by adding tape to the lighter blade. Then I put the prop vertical and see if it drops. Note the side of the hub that is underneath, flip the blade 180deg, do it again and check hub. Then balance hub to make it hangs in all 8 positions of...

That's a good idea. Is it sticky enough to stay on though? I hate the velcro/superglue method. But it works. I may get some tape and try it.

They're M2, standard thread. Sent from my Z30 using Tapatalk

Hi That is not for the top holes, that's for the holes in the mounting plate. I need the spacing for the holes shown below:

Hi I am getting a plate made for me to bolt 2 retracts to for my quad. However I cannot find anywhere that states the hole mounting dimensions for the top holes. Retracts are these ones...