Search results

it looks like i enjoy more on my Parrot AR 2.0 drone ...lol

Guys, i tried so hard for my quad to work but its just that the motor is really strong on f450..it doesnt work, its a flying desaster...solution: change to smaller motor...thanks for all the advice,, ill try f550 dji motors and dji opto, dji -wkm...if i still fail? thats it for me, ill just...

nisouck <<<apc 12x6 but i changed it with 10x4.7 hoping to see it even just to hover for 1minute :) but no luck....flame wheel 450 whole thing attached..it weigh between 2.5 to 3lbs. Idk how to say it in details but when i start the motor (CSC) motor turns on high rpm, like 40% of its motor...

I program each esc (page 2 table 1)(http://mgm-compro.com/manuals/en-man...d120608-02.pdf) except i change brake to off..anyway i tried one motor again...pull the control wire from dji MC and put back the red wire and connect it to Rx throttle.. and it runs ok with low speed to high speed on tx...

http://mgm-compro.com/index.php?tid=brushless-speed-controllers-for-airplanes-a-series-40

I have a Dji W-km on 450 flame wheel axi 2814/22 motor and MGM compro A 40 esc using 4cell batt. DX7 tx. My problem is everytime i start the motor the idle speed is too fast that i have to tie down the quad on the ground, or it will fly right-away and dont know where it may stop ascending :( i...