Search results

I've been continuing to do some tweaks in order to improve the responsiveness and smoothness of this mount, in order to get better video performance. There are two distinct issues with most setups, servo "jitter" and response lag to MC gimbal output corrections/changes. Most jitter is caused by...

I agree with Ken, it really depends on the AUW weight. My VC-600-X8 weighs 2953 gm and I initially set my gains to 150%, with all the basic gains tied to a knob. It had a quite a bit of oscillation, when I first flew it, so I dialed it down to where it stopped oscillating. I then hooked it back...

Excellent. Do you have any pics of the mounts? Did you do anything to them, other than replacing the servos? Which servos are you using? -- Gary

You Brits have a wonderfully understated sense of humor. That was very funny. :highly_amused: I haven't tried the Failsafe mode on mine yet, but it's on my to-do list for today. Even with all the "under the table" activity going on, it is amazing that it comes back that close to where it took...

Yes, I do have a failsafe switch. I programmed a two-position switch to be mixed with the Manual/ATTI/GPS 3-position switch. When the two-position is in the "ON" position, it simply adds about 25-30% to the 3-position switch value. Normally, this is set to go from -80% to 0% to +80%. With the...

I have an X8 setup that uses S.Bus, and I have a slider assigned to control the pitch angle. It works fine. You just need to assign it so that it controls the X3 input on the MC. If you look an Page 11, in the manual, it shows that when using an S.Bus setup, X3 gets assigned to channel 6 on the...