Search results

https://www.sparkfun.com/products/9232 That one you link was SMA to SMA you need RPSMA Male to SMA female.

For stills just change cameras, Canon S95 Panasonic LX5 type of thing would be more than sufficient for industrial use disregarding the zoom of course, to be honest the zoom aint really too vital with Aerial, the whole point of it is to get a camera where you want it.

Just some thought Rich, regarding cameras, I take it its more of an industrial purpose you need it for, have you thought about a CCD or 3CCD camera, it eliminates the jello efffect when you just dont have time to sort out vibration otherwise. Camcorders tend to be lighter and have better zoom...

Rich, you need to be looking at a large SRH on parallel 10S lipos to get anywhere close to even 20mins. New battery tech sound promising though.

I think the material the DJI frames are made of transmits vibes very efficiently. never had as much trouble with vibes than with my 450 and 330.

I have a couple of Naza's also. not sure what I'm going to use on my new build, its going to have to do a CS gimbal justice, so I think I'll reconsider my original Naza GPS plans. Probably go with Hoverfly and Radian or Ardupilot. Agree with you on the Naza. Although its very very good in many...

No but since you mention it, I'll check it out and see if It looks feasible to fit the mounting plate. The CS 2X is about 700g, + camera... might be a little heavy for a 550 with 10" props, best to be on 4s if your going to try. I dont think you can drill out the F550 bottom plate can you? for...

I am planning to mount one on a Vulcan 900 hexa, from what I can see, I will have to devise some kind of vibration absorbing setup as I wont be able to use the vibration absorbing gear that interfaces the CS Gimbal to CS frame.

Just fishing for some views on Lipo connectors, I use Deans, pretty secure but a bas**rd to solder. never get that warm feeling even with a good joint..(solder!!!) Reckon the HXT's look better from the soldering point of view, but not sure about security of connection.

Ditto, my gimbal became a smooth tilt and roll dampener rather than a stabilizer. I firmly believe this is more to do with the Naza as a gimbal controller than any failing in the gimbal, Its only doing whats its told to do after all. OK fair enough the XA servos are not the best but the gimbal...

Happy B'day Bart, have a gid een!!

I'm not sure Totality, I cant find any spec on the G50 and G20's at all. A lot of the performance is down to the FC or gimbal stabilizer though.

Thanks for posting that link Bill.:tennis: I've so needed that extension

Bear in mind you are getting savox hi speed servo's with the Aeroxcraft, so if you add the cost of upgrading the XA servos, the price gets a little more even. Also bear in mind that the XA is almost half the weight of the Aeroxcraft.

It wont carry a Nex5. It mounts the XA load hangers which clip onto the load/landing skid rails. It will take any stabilization system. dont know what the XA G50 and G20 servos are. the biggest camera it will carry is a canon S95 but with no room left for AV out lead. Its actually a gopro mount...

PM'd you.

Beautiful place Bally, you'll get some nice photo's around there if your going for the AP thing. FPV must be awesome over there!!

Just got a chance to watch this....Inspirational Lec...loved every second of it, no lingering there, just bang bang bang, nice editing and creative shooting. Steve

Hi Bally, where you flying?? Steve

Nice job, looks good. If I had not just bought a frame, I would probably buy one. keep it up.