Search results

I just got this from Ready Made rc. I had ordered the package with the lawmate but this is the one they sent, said it was better option. Will the lawmate trans not give me the interference I am getting now? Should I send this one back? I depended on their expertise.

drops with no warning After moving the transmitter I managed to get the quad in the air. At about 80 ft distance and 20ft high it just dropped to the ground. I moved the transmitter to different areas on the quad but either the motors wont start or it does and goes a short distance and just...

by the way what manual are you talking about?

You were right kloner, I had my transmitter at the bottom of the quad and now put it on top instead and all seems to be fine now. thanks Shaun

The DJI transmitter flashes red and green when I plug in the quads battery...Shaun

I just recieved my new FPV setup from ready made RC. It is a 1.2-1.3 ghz. I have it on my HT-450 Naza Quad and DX6. Quad worsk and flies fine goggles and transmitter work fine, but when I turn on the FPV transmitter the Quad won't start, as soon as I unplug the trans it goes. any thoughts...

Well I just lost my quad. I only about 200 ft away and maybe 75-100 ft high and I lost signal. It was just over a bluff of trees so I didnt see it go down. It could be in my pond which is 12' deep, too bad. Not sure if it was the transmitter or what. so I'll be looking for another quad and...

Sorry no pictures. Power comes from a 910 mah 11.1v lipo.

The one antenna is a 5.8 patch vitenna, and I have the Mondo stinger receiver...

I'm using the ones that it came with,about 4" long. I also have some round ones, I got from Quadrocopter.us but there is no name on them. It doesn't make any difference. I can be less than 100' away and it will begin to lose signal. Or that is what it looks like. Shaun

I have a question for you TJ. I have a yellowjacket 5.8 that I use with some Vuzix goggles. I am plugged into channel 1 and for the most part picture is good until the receiver starts to cycle around and the picture quality goes down. I'm not sure why it keeps cycling around but it won't stay...

Ok. so if I would hook up mk tool when I'm flying the voltage would be at 14 and then go up to 15 when no load?

the weight of my kopter is about 7.6 lbs, and the battery is a 6000mAh 4S1P 14.8v 35C 210.01 amp continuous 70C 420.0 amp burst

I have my low voltage set at 14 on mk tools. My low battery starts beeping on my AD-6HL and when I check the battery it is never lower thank 15.2-15.3v Anyway to get it lower and more flight time? Shaun

I have the same problem. thanks for this, great idea... Shaun

Hey Matt: other than the camera, what would you say is your total cost$$ Shaun

Well got my kopter to start the motors but now it only goes about 1/2-3/4 throttle, not enough to lift off. No errors in mktools, can't figure it out. SM

After receiving my AD6 back from repair I tried to start the motors and there was a continuous beeping and my receiver was not lit up. I re-bound the radio (JR X9503) to the receiver. That working I tried to start motors again and this time the receiver lit up but there was a continuous...

After you bind a multirotor and it has been in operation for some time what would make it lose its bind, if that if the right term? Shaun

Are you flying manually or with AH and PH?