Search results

You have the Receiver type set to "D-bus" in the Assistant for S.bus correct?

Ok so it only did it through S.bus... Try another cable with S.bus If it's a bad cable you want to ditch that one ASAP

What switch do you have it assigned to & can you change it to a different 3 position switch to see if your current one is bad

Take a video

Sounds like you might need to adjust the mixing... as 2 values might be positive while one could be negative in the gear to gear mixing

While you are in the different modes just adjust the values until it stops bouncing in and out and is rock steady in the center. The values can be different from transmitter to transmitter especially with the forced failsafe mixing. Let me know of you need anything!

Watch some of my set up vids as that might help with the values for the mode indicator position as well as the 10% minimum throttle for failsafe.

Sweet I'm taking my baby steps since I won't be going UHF for months now. Going to rock the 5.8Ghz and try different antennas once the Diversity box is in stock. I wish I was already UHF to get that RSSI through the core

Gear channel sub-trim is ok to attain your Mode selections via the assistant but you don't want any stick trim/sub-trim. After swapping out the Rx please post back

I ended up using my AR7010 vs. my 8000

I would go into that model selection and check all your programming trim/sub-trim areas. Check the front screen as well to see the trim indicators

Ahhh damn Sure there isn't any subtrim or trim hidden in that models memory? DJI ESC's?

Welcome!

Yup just ignore and ream out to 8mm. With the Graupners I used a spacer from gothelirc.com as well under the prop to make sure they were tight since the Graupner root is thinner like below.

Yea, using stock DJI motors you'll have to team out just about any aftermarket prop under 10" and most even at 10" unfortunately.

With the lighter set-up a smaller prop I have found to be more stable in FFF and windy gusts but the 8" props were way too small for my 3S set-up. You want to try and achieve hover at "mid-stick" throttle while in Manual mode. Motor Kv has to do with set-up as well, Higher Kv motors or higher...

You taking fun FPV or more of Aerial Photography?

I assumed the OP was using the DJI ESC's since he said the values didn't work at all with Trappys suggested settings :0)

I too spend much of my FPV flights in Atti mode vs. Manual as I am still learning manual here and there. Mine are as follows 141-141-120-120 91-91 both the 141's and 91's are on 8FGs knobs and can be adjusted on the fly as in manual mode I increase he 91's (Attitude gains)

You just looking for gain settings? are you flying in Manual or Atti mode & what prop size?