Search results

Nevermind. Took the risk and combined it anyway. All is good.

Got an F550 I am custom building with a thermal camera. Running an iOSD mk II as the iOSD so I can switch between the FLIR and a small FPV camera. The FLIR runs off of 5V input from a BEC I am using. THe FLIR camera uses the VID1 & GRND pins on the input of the iOSD. The FPV camera uses...

Upgraded from the S800 to the S900, and used the same gimbal. However, when I rotate the S900, the gimbal slowly tilts, and takes a few more seconds to stabilize. Very annoying, and never happened on the S800. Firmware is up to date. Here is a link to show you what I mean...

Got a new DJI Phantom 2. Put in the mini iOSD and no matter what position my switch is in, ATT always shows in the display. Never GPS. It does detect satellites. Ignored it, but today my P2 locked up and fell hard to the ground only about 100 feet away from me. It was showing at least 6-8...

Sorry, but thats not what happened. When I said I was fliping switches, I should have been more specific. I was only switching the mode switch and it never stayed in Manual mode. As well, when it was out of control, the control sticks were center and also throttle was low. I did test the...

Well what other information could I give? It crashed because I didn't realize that failsafe was activated. What I am trying to understand is why when failsafe was activated it behaved like it did. What information can I provide?

Hi, I am new to the DJI F550, but not new to flight with multirotors or helicopters. Over the past few weeks I have built a new DJI F550. Its all stock, using 8 inch blades, Naza-M w/ GPS using spektrum dx8 radio. Using videos and guides I have found online, I have successfully been able to...