VU not functionin as a BEC

1.8turbo

Member
I've been flying my naza and I'm very happy with it so far, I've just had one issue. I did have an error on set up, pmu err or voltage low I think. Like other people stated when searching threads, it went away after updating/calibrating.

The issue is that the VU unit wont power anything and the voltage protection wont work. The light functions normally per flight modes/sats and I'm not too concerned about the battery protection, I'd just like to know why the VU isin't acting as a BEC as it should. I currently have one escs bec powering the hex.

I could switch to my gimbals second bec output, besides my escs bec which I would disable, should i disable the red wire from the VU or red and black?
 
Last edited by a moderator:


STI-REX

Gettin Old
Would you care to enlighten us as to what the problem actually was so others can learn from this
 

1.8turbo

Member
Ya, I had it hardwired to my distribution board and i managed to put the red wire to - and black to +. Flies just fine, there was no damage.
 

Top