Futaba T8fg V5 plus R6208SB is enough?

[7lkf7]

Just planning to get new Drone setup, but not too sure is my remote is enough for me.
Drone will be Hex and DJI WKM as FC, plus need one channel for Gimble tilt, and one channel for control camera shutter, video .also need one channel for landing gear.
my remote shows support 14 channel but my receiver on up to 8 channel. looks like I have one channel short, is that correct? Four channel for Drone, one for POI , one for flight mode, one for Gimble, one for camera, and one for Landing gear. total 9 channel required.

can I ass another receiver on my drone? like one 8 channel receiver plus another 6 channel receiver so totally 14 channel.

Thank you

 

[violetwolf]

Although it is technically possible to bind more than one receiver your T8 can only broadcast a maximum of 8 channels.

The Taranis radio system is what I use. 16 channels, some sliders on the bottom side to operate gimbals and only $200!

 

[STI-REX]

I am running a T8fg super with an R6208sb receiver and I am using an sbus hub along with an sbc sbus decoder and operating a Naza on sbus 1-7 a video switcher on channel 8 and then 3 channels running my z1 tiny 2 gimbal all installed on my QAV520 V2 ( G10 520 mm arms )

So R6208sb into sbus 3 way hub 1 x lead from hub into naza and another lead from the hub into the SBC sbus decoder which has 3 assignable outputs (needs programming device readily from Futaba stockists )running my gimbal

Video switcher plugged straight into channel 8 port on R6208 RX

2 x decoders can be plugged into sbus hub along with naza giving 14 available channels from The T8FG