Cleanflight and configuration

Keystow

Member
Morning all,

So I just received my new Naze 32 Rev 6, and was trying to connect it to my computer to flash firmware.
I started by trying to install the CP210x USB to UART Bridge VCP Drivers so that I could get the Naze 32 to be
recognized. I've tried both the Windows Vista version on one computer and a Windows 7 for another computer and both are saying no drivers were found yet the installation finished properly. I keep getting the unable to open serial port. Has anyone had this issue and what was done to correct. Otherwise i'm dead in the water to configure the Naze 32.
 


Top