Dennis Laman
New Member
HALP!!!
I was flying my 450 quad today when I noticed that I had ZERO satellites after a minute or 2 of flying time and the quad went manual on me. Scared the crap outta me! All of a sudden it went crazy on me going where it wanted to go and then, the sats were back and all was good. Dam, it happened a second and a third time during the same 3-minute flight. I landed the quad safely.
Anybody know what's going on with my Minix?
Here is the log from the blackbox if that will help.
http://log.xaircraft.com/#2015_08_16...72_169.1.05.04
I just checked today with my continuity checker that pins 1 & 2 check ok but pins 3 & 4 are different. On one end Pin 3 goes to pin 4 and the other end pin 4 goes to pin 3. Is this normal? See photo below.
I was flying my 450 quad today when I noticed that I had ZERO satellites after a minute or 2 of flying time and the quad went manual on me. Scared the crap outta me! All of a sudden it went crazy on me going where it wanted to go and then, the sats were back and all was good. Dam, it happened a second and a third time during the same 3-minute flight. I landed the quad safely.
Anybody know what's going on with my Minix?
Here is the log from the blackbox if that will help.
http://log.xaircraft.com/#2015_08_16...72_169.1.05.04
I just checked today with my continuity checker that pins 1 & 2 check ok but pins 3 & 4 are different. On one end Pin 3 goes to pin 4 and the other end pin 4 goes to pin 3. Is this normal? See photo below.
Attachments
Last edited by a moderator:
