I'm having an issue setting up a WKM on a new X8. I have used this controller previously on a couple of different y6 configs, but did a factory reset to start with a clean slate. FW is 5.24, and I'm getting an error when trying to upgrade to 5.26. Receiver is Futaba R7008SB, and WKM is in Standard (not DBUS) mode.
The channel monitor has some funny stick positions with sticks centered.
When I go to calibrate sticks, I see this:
The sticks don't show their full travel, and don't center. Watching the monitor on the transmitter does show the full +100/-100 travel, and there are no custom mixes or end points applied.
Any advice? Thanks in advance!
The channel monitor has some funny stick positions with sticks centered.
When I go to calibrate sticks, I see this:
The sticks don't show their full travel, and don't center. Watching the monitor on the transmitter does show the full +100/-100 travel, and there are no custom mixes or end points applied.
Any advice? Thanks in advance!
Attachments
Last edited by a moderator: