Hoverfly Hoverfly gps setup to reciver

[kjella]

Hello
i have no mounted my hoverflygps and done all the calibrations and everything looks good
know i have to assigne the transmitter and a 3 way switch,i fly the jr Zero 11x
do i have to go move the cables from my proboard to the gps board or am i missins somthing here??
i lookt in the manual and is it the gps board with all the cables from reciver??

what to do here?
thanks

 

[tahoelight]

As it shows in the users manual, you run a servo wire from the lower right pin out on the HFP board. not the GPS board. So, connect low right pins to a free channel on your receiver. Assign a 3 way switch which controls Off, Position Hold, Return to home. The GPS and HFP boards are connected by the pins that are plugged in when you stack the two boards. Does that make sense?

I'll be curious to hear how the GPS performs.

 

[kjella]

thanks
i will try this and i will report how the gps work
i also have the ublock gps ,but i wil test the orginal first

 

[kjella]

ok know it is working with the 3 switch positions
i try the gps hold today and i think it need some tweaking?
is there something to do with the gps gain or something like that??,or is it just off-on,and nothing to adjuse?
the octo hvae the bow toilet effeckt,!!it goes round and round like the water in the toilet.