Hoverfly Hoverfly OSD wiring?

kjella

Member
hello
i want to setup my osd with my 5,8ghz tx and i dont understand how to wiring the osd to my tx
i Have the hoverflypro black board.

i have been looking in the hoverflymanual there it says osd in,osd out
is the first pins just power to the osd (12v)?

can someone explane to me how to setup the osd
thanks
 
Last edited by a moderator:

The signal wire (yellow or white) comes from the camera into the OSD in. The Camera Ground goes to the OSD in. DO NOT RUN CAMERA 12V POWER TO THE OSD Power. I believe it only takes 5v. Although I don;t run any power to mine, Just signal and ground. I bypass the power wire.

Then, run a ground wire and signal wire from the OSD out to the Vtx. Basically, you are just placing the OSD inline between the camera and the Vtx. Just not the power.

Does that make sense?
 


kjella

Member
thanks it is working now.
i looked at the voltage on the osd it said 4 cell lipo 16,8 volt
but i want it to be like a 6s lipo and i want to se when i have to land the octo at 21,9 volt ,what to do??
 

Stacky

Member
thanks it is working now.
i looked at the voltage on the osd it said 4 cell lipo 16,8 volt
but i want it to be like a 6s lipo and i want to se when i have to land the octo at 21,9 volt ,what to do??

Unfortunately the HFP OSD doesnt give correct readings for the voltage if running 6v. I dont think they ever fixed it and I dont think anyone ever found a solution. Sorry.
 


Top