I am not to XAircraft and the SuperX. With all the positive reviews I have been reading the SuperX is cost alternative to some of the higher units so I decided to give it a try.
It has been about three weeks and I have not been able to figure out my throttle direction problem. The only time I am able to start the motors is when the sticks are top-center or top-outward positions. It will start but the throttle travels in the wrong direction. When I replace the SuperX with my Naza version 2 then everything is correct. The throttle start from the bottom. To make sure it is not SuperX, I installed it on another drone with a different make and brand of ESC and motors but with no success. The same situation occurred on the other craft as well.
Receiver: Futaba T14SG with R7008SB receiver (using the SBus connection)
Drone 1: Tarot T960 with DYS 40amp ESC and FoxtTech 5008 motors
Drone 2: Tarot T680Pro with ZTW 30amp ESC and SunnySky x4108 motors.
They all calibrated fine but when I hooked up the SuperX that is when the revers issue reappeared. I even went int the transmitter and reversed the throttle but when I did that noting happens no matter which orientation.
Any and all input, guidance, suggestions and processes will be greatly appreciated.
It has been about three weeks and I have not been able to figure out my throttle direction problem. The only time I am able to start the motors is when the sticks are top-center or top-outward positions. It will start but the throttle travels in the wrong direction. When I replace the SuperX with my Naza version 2 then everything is correct. The throttle start from the bottom. To make sure it is not SuperX, I installed it on another drone with a different make and brand of ESC and motors but with no success. The same situation occurred on the other craft as well.
Receiver: Futaba T14SG with R7008SB receiver (using the SBus connection)
Drone 1: Tarot T960 with DYS 40amp ESC and FoxtTech 5008 motors
Drone 2: Tarot T680Pro with ZTW 30amp ESC and SunnySky x4108 motors.
They all calibrated fine but when I hooked up the SuperX that is when the revers issue reappeared. I even went int the transmitter and reversed the throttle but when I did that noting happens no matter which orientation.
Any and all input, guidance, suggestions and processes will be greatly appreciated.