Hi guys, my first posting on here, even though I've been lurking in the shadows for a while now, learning as much as I can.
Im currently in the process of building a skyjib X4 and have run into a bit a problem trying to mount the KW10 motors on the supplied mounts. The motors are so wide they cover half the bolt that joins top and bottom mounts together making them impossible to tighten.
Just curious to see if anybody ran into similar problem and how they went about it. I know that droidworx have new coaxial mounts that give extra clearance but I'd like to see if I can make the old mounts work first.
Another question I had is should I leave in the rubber grommet and o-ring for the coaxial configuration? In the manual new mounts are used seemingly without the grommets and o-rings.
Roman
Im currently in the process of building a skyjib X4 and have run into a bit a problem trying to mount the KW10 motors on the supplied mounts. The motors are so wide they cover half the bolt that joins top and bottom mounts together making them impossible to tighten.
Just curious to see if anybody ran into similar problem and how they went about it. I know that droidworx have new coaxial mounts that give extra clearance but I'd like to see if I can make the old mounts work first.
Another question I had is should I leave in the rubber grommet and o-ring for the coaxial configuration? In the manual new mounts are used seemingly without the grommets and o-rings.
Roman