Recent content by treeline

Works great above freezing for me. Totally worth the money. Here it is around 50F. All filmed with the Tarot 2D. Still, I've filmed in some pretty extreme conditions and 37F just seems too warm for the kind of behavior you're getting. I'm guessing some of the weird behavior at really cold...

In my experience the Tarot 2D totally freaks out in cold weather. BUT---for me it has to be colder than freezing. More like sub 20F for the erratic behavior to start. Go below 0F and it's pretty much worthless. One thing to test is to try resetting it when it begins to act up by simply power...

Ha! As it turns out, the solution to the Naza/TX issue mentioned above was the solution to the Tarot tilt problem, too! After upgrading the Naza firmware, the Phantom became locked into failsafe mode which made it appear as if the TX and RX were not communicating or not bound. Normally the Naza...

I have not. Thanks for the suggestion. Unfortunately I am having other issues right now. I upgraded my Naza firmware last night and it's caused an issue with my TX not binding properly. As soon as I have control back, I'll give your suggestions a go on the gimbal and report back.

Thanks for the reply! I press enter and also save the changes to flash. Yes, it does tilt a bit. I can use the lever on the back of my standard Phantom controller (just purchased the Phantom last week so it's the most current model of the "v1") and it will tilt from looking straight ahead to...

Whoops, the screengrab shows "Motor Reverse" checked under the tilt section but that setting seems to make no difference. Either way, it won't look down.

Just installed my Tarot on my Phantom and am having a strange issue. The tarot will only tilt from 0 to +32 no matter what my MIN/MAX settings are. Currently I'm using the recommended settings from XAircraft America. I've only hooked up the white wire to T and have disconnected the black wire...