Recent content by tjdeerinck

I completely agree, Jeff. It was promised, I bought a few of them since they are the best. So they build a Ferrari with a VW engine, and then build a VW with a Ferrari engine? Come on XA.....deliver on your promise! ~T.J.

My feeling is we are going to see some neat stuff real soon for SuperX.....Ground Station, Bio-Motion, etc...... :) ~T.J.

My pleasure! I always try to help anyway I can. So many have helped me here! ~T.J.

It works on them all! I have used on Windows 7 64bit, Windows 8 64bit, and Windows 8.1 64bit. Also on Windows 8 32bit but I am now running all 64bit. You will be good anyway you choose! ~T.J.

Not I..... ~T.J.

As Buzz Lightyear would say, I am not flying, I am Falling With Style!! Same with an airborne multi rotor with out power.....falling with style....with a VERY HARD LANDING! ~T.J.

David, When I turn off the TX, the LED now blinks double red in the same pattern RTH does. It is definitely working as it should. I tried the FS as the X8R instructions said, and this only put the Super X in ATT mode. Go figure. Anyway, resetting FS on the radio after the burn is no big...

Just to circle back and provide an update!! Using a Taranis, Super X using SBUS, and an X8R receiver, FAILSAFE WORKS PERFECTLY!!! Yes, using SBUS. Steps: 1. Setup everything possible in Companion9x you normally want. Set Receiver mode to D16 for the X8R, and Ch1 thru Ch16. 2. Click on...

David, If you look at that video closely, you will see it is SBUS. He told me that he did NOTHING at the receiver and everything in the Failsafe Tab of the Companion9x software. He said put it at 100% on Ch6 and that is all he did. Gonna try another message to him to get more details...

Crazy thing is this shows it can be done...... https://www.youtube.com/watch?v=HZCPft1VltY I asked him how he did it and he mentioned putting FS in Custom, setting channel 6 to 100% in the FS on the TX. Beating my head on concrete!! ~T.J.

From what I understand, you don't need it. I mounted mine right on the mount and it works fine. ~T.J.

Ok, so forgive my Noobness as I just got the Taranis..... I am using Companion9x, so in the TX, under FS, set to "No Pulses", where do I then set RTH or the rule? Thanks again!! ~T.J.

Thanks David! But will this still give the desired end result of a RTH if signal is lost from TX? ~T.J.

Anyone get this combination working properly with Failsafe / RTH when using SBUS? If so, how....... Loving this radio but want to make sure I have it all the way setup. I have everything working, including a RTH switch. Setup Custom Failsafe, but when I power off the TX, I appears to put...

S.BUS channels will only be limited by TX, so yes, you will get 16! SuperX will grab 1-7 on S.BUS. ~T.J.