Recent content by thescorpion1001

Thank you again LowFlier!

Thanks for all the replies! So in short i cant connect a ubec to the kk2 to supply power instead i plug it in the rx which will power the kk2? Is that correct or i cant power it using m2-8 but can use other + - connections on the board?

Thank you!

Hi i ordered 4 multistar 30a esc (opto) and 2 kk2.0 boards. Where do i connect the ubec to power the board if i only have opto esc?

I will be using an APM 2.5 with telemetry and gps powered by a 5000 or 6000 mah 4s lipo. Im just going to fly it around w/o a camera. Im building this because my f450 quad got lost when my transmitter unexpectedly turned of and my quad fell. I was able to find the cause and it was a battery that...

And yes i have run ecalc it said max amp per motor is 22.49

Im going to build an h-quad using this motor combo. What AUW do you reccommend?

Will a t motor mt2826-8 spinning an APC thin E 15x4 prop and an e-flite 30A esc work with 4s battery? Will it overheat or make "magic smoke"?