Recent content by Stratrascal

On the Calibration Page. you can see the posistion of your sticks. If you did not do that that is probably why it wont arm.

are you looking at the light on the naza unit? That always stays red.

Have you used the Naza Assistant software to configure it? you will be able to tell the directions in the software to get your reverse switches.

Ok, those should not be a problem.

It sounds like you are going into fail safe.

What Kind of Speed Controllers do you have? I had the same problem. Try this. energize the speed controllers (do this without props installed the first time) then plug in the Naza bec. I bet it works. I had to get different speed controllers. Do you have Hobbywing?

I had my NAZA working pretty good. But now when I push the throttle the motors rev to just above Idle until I Reach about 70%. I am sure it is in the proper mode. This is just wacky and I can't figure it out. I sure would like some help with this. Thanks Bart

I hava a NAZA with gps. I had it working pretty good and just needed to program my radio and the assistant software a little better. Now after I arm the motors and increase the throttle the motors stay at the same speed (slightly faster than idle) until I get the throttle to about 70%. I do not...

Both I am mainly involved in the physical design of the boards however I do have some electronic design skills and if the project exceeds that I have several friends that can take up the slack.

In my whole life I have not met another Bart. I am named after a Bartholomew but my name is just Bart. Just to let you know I am a PCB Designer and am looking for projects to help make my profession part of my hobby. So If you have any ideas let me know.

This looks like a great site I am looking foreword to talking with all of you, I have a flame wheel 450 with scorpion 450 motors Naza with GPS and gimbal. Geez it is getting heavy. Flies good tho.