Recent content by stepino

Mám tu P3XP_V1_20130128__v58_28.hex - kdyžak SZ...

I am asking because we have problems with 24 fps in the past - cannot find hdmi converter which can handle this frequency. Good to hear that Connex is ok with this mode. But the range of 200m doesnt sound good :-(

Hi, can somebody confirm, that european units switched to indoor mode have same range like units from the US? And is the range almost close to that declared one? How does it work with the GH4 in cinema 4K 24p mode? No problem? What is a boot time, from power-on to "image ready"?

Hi, have you tested this gimbal with GH4 in 24p cinema mode (and C4k resolution)? Does the built in HDMI to AV converter handle this mode ok? And what about Lightbridge? From specs I see that it doesnt supports 24p mode, can you confirm it please?

I have not solved this issue yet... Tested "almost" everything. If I power the NAZA/PMU first, than GCU/Zenmuse I have clear image for couple of seconds befor the gimbal initialise. Right after the motors starts working, lines are there. Tested three different cameras (Black/Silver) no change...

Some simple set from HK. Next test I want to try is to connect LCD directly to video-out on GCU...

Hi, Same problem here... I have tested similar steps as you with no success. Maybe try to swap PMU? Or GCU? Edit: I have tested another gimbal, another GCU and another PMU. Nothing changed. I have no idea where this interferenc come from... :-( As cedhart says - befer the gimbal (or Naza?)...

Last config file available was not compatible with last assistant software (2.14). So I guess they will only update it with newer one?

Hi, nobody has solved this issue with latest Picloctoolz? I have seen some other reports with same error here. I have asked George too by email, but no response. I could revert to older firmware and Toolz, both running fine. Picloc 3X Pro V1, Windows 7 64bit

How do you starting them? Try all other CSC combinations. Did you recalibrate your RX after upgrade? Also check channels deflections on View tab in the assistant sw if they are full to both sides. I have similar problem, channel deflections wasnt full and CSC doesnt "trigered" and...

Hi, I have upgraded my Naza V1 to new firmware with almost no problems (I have reseted it to default values, recalibrated RX), but: After upgrade it flys nice, but CSC works only in one way (both sticks to the center), but I was used to do it in opposit way - both stick outside. I have...

Same error here... I am forced to close the application and cannot configure the Picloc (3XP v1).

Will be available for Android devices too?

Hi, we have just builded F550 with NAZA and GPS. Stock motors, ESCs and props 10x4,5, battery is 3S 4500. AUW 1,5kg. After 3-4 mins of flight it takes 4000 out of battery. I am thinking what is wrong in my setup and how to improve flight time to get values like olof has... Any suggestions...

Hi, one small qustion please: charging should start automatically when I connect the battery to the charger? Thank you.