Recent content by simobn floyd

Was flying , tried a spin and it seemed to loose lock and the wind carried it backwards. Is this the yaw problem people are taking about with the v2 ?

So if I spin around with rudder all other channels stay locked into position?

Pm you

If iam in gps mode and push a stick like rudder does the gps lock turn off on all channels or just the stick input you have made?

was at the end of my tether so I flashed the naza lite with the m v2 software and now its perfect, tried it with the spectrum dx7 and was all good, so I refitted my dj6 what the shop said was faulty and hay presto it works perfect.

It was off ebay but if it was faulty why would everthing work and calabrate in the naza.anyway trying it with a spektrum tx and rx as soon as I can

O ye its not the fc because he swapped it for a new one

Quad is back from shop, guy said its my tx.i am using the phantom dj6, he said he has put this futaba on and it works but he also had to put 20 subtrim on the throttle channel to centre it on the naza software? I asked him about dji advising not to use and trims or subtrims, he said thats...

Its at the shop, guy had a quick look but did not come up with anything, rang today and he said dji advised tx needs calibration but I have done it in the naza assistant and in the phantom rc software, so the shop is going to test fly it and report back soon.will keep you updated

going back to the shop on Thursday to see if its a faulty unit,will repost after that

weight without gimbal is 1230g as posted in first post, 1460g with gimbal ,tried the dji tx firmware upgrade, that changed the front power light to green and mucked up my x1 pot, that tuck about 2 hours of tweaking to get the full range back and quad still flies the same, been down the...

Whats landing mode? Never heard of it? Heard of fail safe and rth

Not calibrated it in the app.everything on the tx is correct and does what it should in naza software all switches work, all stick centred and in the green, when you push left and down on sticks all move left on monitor screen

Single flash.I am using dji tx so there is no trims or sub trims to adjust, all switches are asigned and everything is working on tx in the naza software,auw is 1460g with gimble and 1240g without gimble.i removed gimble and retested and it was just the same

did you sort the fault out?