Recent content by Shahar Keren

Hi, The range issue is unlikely o be related to the water. Did you change anything in the installation or configuration? Position of the Air unit? another device working on the 5GHz band, or change a device's frequency?

Hi, We've been testing CONNEX with the GH4 and it's working great. In the following article you can find a list of supported resolutions: https://connexuav.zendesk.com/hc/en-us/articles/205148815-Supported-Resolutions Thanks, Shahar

Hi, CONNEX Air unit consumes 5W, while the Ground unit consumes 6W. You can also refer to the following article on the CONNEX support center: https://connexuav.zendesk.com/hc/en-us/articles/204714495-How-long-does-the-battery-last-

My pleasure! It's important for us to have close connections with our customers, to better understand the needs, requirements and concerns.

Hi, I think you all know me by now, still as this is my first time in this discussion, I'm working for AMIMON's Customer Support team. About the HDMI cable, we've realized that one of the most common integration is with the GH4, and we've found a cable that fits well into the Z15 GH4 gimbal...

It's true that Bolt, Tomahawk and CONNEX all based on AMIMON's technology and chip-sets. Nevertheless, on both Tomahawk and Bolt you will not be able to extend the range above 2k feet (o.6km). CONNEX can reach 1km in LOS (Line Of Sight) conditions. CONNEX also offers S.BUS support and MAVLink...

Hi, AMIMON is providing accessories kits, including spare antennas to its re-sellers. If your CONNEX re-seller can not help on this matter, please send me a private massage with the re-sellers name and I'll make sure you can get back to work with your CONNEX ASAP.

Hi Elossam, Here-under you can find the CONNEX Users Guide. In page 48 you have a list of supported resolutions. http://connex.amimon.com/sites/connex/UserContent/files/Amimon%20CONNEX%20User%20Guide%20-%20English.pdf I have a GH4 in my lab, and it's working fine with CONNEX. Please note that...

Hi Carapau, We've tested extensively the antennas we provide with CONNEX. I'm sorry, but I can not commend on other antennas which we did not try. From my experience with RF equipment, there is no replacement for trial and error. If you have a few clover leaf/skew plannar antenna, i think it...

Hi, DSLRPro made a nice video comparing the two: https://connexuav.zendesk.com/hc/en-us/articles/204438969-DSLRPro-Integrated-on-Z15-Gimbal

Hi Carapau, Antennas installation has a huge affect on range. See the video and article below for instructions how to mount the antennas in an optimal position...

Hi Stratifier, You are right. As of today, the HDMI cable will wrap itself, if you'll conenct it before the gimbal calibrates itself, or if you're not being carful during the flight. The solution AMIMON is working on will be to place the CONNEX Air unit on the back side of the gimbal (on the...

AMIMON is working on a solution for this use case, to enable 360 degree movement of the gimbal. Till than, this is what I can offer: https://connexuav.zendesk.com/hc/en-us/articles/204071159-How-to-connect-the-CONNEX-Air-Unit-to-the-Z15-GH4-HD-Gimbal-Zenmuse-GCU-Video-

CONNEX is based on AMIMON technology, which adds <1ms delay. The only lag you'll have is form the camera itself, monitor, HDMI chips, etc. See the following Flitetest (GetFPV) video for the same use case...

Hi, CONNEX configuration depends on the region from which the system was bought. If the system was bought from a re-seller in Europe, you'll have the two options of 25mW or 200mW, if it was bought in the US, CONNEX will have only one configuration. Note that even units sold in the US do not...