Recent content by sentiensx

Sound like just sync? What do I do-re calibrate esc? If you watch my video in the last 10 seconds I get #3 to squeal and stall. I have only been able to get #1&3 to do this http://youtu.be/JyAb5x9FNnA

Im not sure the ESC and Motor are matched. They are both branded 'Century' but I know that they are just OEM. The motor is sunnysky for sure but I dont know about the ESC. I guess I need to leave the prop on it to slow it down and cause the motor to torque and put load. I was definetly seeing it...

New build, its only had 6 flights and its hit the dirt sideways 4 times. Broken props arms and landing strut. I am hearing a squeal (I imagine as if you were holding a motor and not letting it spin?) and then the craft tilts and rapidly descends into the dirt. Is it a bad motor or ESC...

Thanks Kloner - this solved my noob problem I had the same problem and this tip from kloner solved it for me. I had the motors arming but after assigning some more switches they would not. I read to calibrate several times so at the risk of insanity re-calibrated them maybe 50 times. It wasnt...

first build of quad and noticed that the arms on the neo 720c are all tilted to the left 2 degrees, one seems more but I didnt measure it. I am thinking they should all be level or tilted opposite if anything. I think this is a manufacturing flaw and all motors and props should be level, on the...

I would like to get a 3 axis gimbal and control it with a knob as opposed to a switch but I dont see a ton of options out there. What are recommended radio controllers for use with a gimbal ? what are people assigning to control pitch and yaw on 3 axis - just a switch or a dial?

I found this "Tips:NAZA supports servo center 1520us." on the DJI wiki which would indicate the naza is not acting as a servo controller for your brushless motor gimbal. So you would need to plug the brushless motor gimbal controller into the naza FC. The naza will tell the gimbal controller to...

I'm not sure I am understanding. I am seeing lots of brushless gimbals with controller cards out there and understand than many Flight Controllers like the naza have some built in gimbal control (auto pitch and roll compensation) as well. What I am trying to put together in my brain before I...

thanks Taz427 Since DJI now has the H3-3D do you know if the naza v2 will control the panning axis on a 3rd party gimbal as well?

I have started reading through threads but there are so many! I am looking to do a build with the naza V2 and 2 or maybe 3 axis gimbal but the DJI gimbal is too expensive and cannot be balanced etc. I understand the naza has inputs to control tilt and roll.... how does that work with gimbals...