Hi. All the custom plates you see have been designed personally on CAD software and then cut on precision CNC. If you need any more info, let me know. :tennis:
Hello,
I am selling a my Mikrokopter Octocopter XL heavy lift frames, as well as many many spares, optionals and accessories. Actually the parts are more than enough for 2!! octocopters!! The original MK frame parts are BRAND NEW as I never used them. I only used the Custom Full Carbon...
Very interesting opinions.. and I tend to agree with both sides. The truth seems to be somewhere in the middle. As for the FW 090, i will try to calibrate the compass again again in a different location and let you know.
Magnet field 123-127 always, and inclination around 61 without any serious changes...
I was very close to the sea (about 20m from the water), so there might be water masses just under my ground that might influence that.. Of course that is only a speculation and I cannot tell for sure. Any...
No, i did not change anything. All my previous settings were entered again carefully into the new firmware, after i deleted the settings.ini file on the SD card. Yes, i did recalibrate the compass twice, but i still had compass error notifications. On the other hand, the octo still flew very...
Yes. It works fine (same flight behavior). I liked the servo relative mode, and the SD card access. However after the upgrade i have some compass errors, and I have to find out why as i did not have them before.
Hello,
I am selling a few brand new and totally unused parts that I won’t need:
2 x Okto2 Centerplates
https://www.mikrocontroller.com/index.php?main_page=product_info&cPath=77&products_id=554&zenid=2ef8717a94206c9b038e3ee596a4045e
1 x Lipo Holder Set...